Show simple item record

dc.contributor.authorGhaedi, Mojtaba
dc.contributor.authorAndersen, Pål Østebø
dc.contributor.authorGholami, Raoof
dc.date.accessioned2024-07-08T11:25:16Z
dc.date.available2024-07-08T11:25:16Z
dc.date.created2024-06-14T13:46:21Z
dc.date.issued2024-06
dc.identifier.citationGhaedi, M., Andersen, P. Ø., & Gholami, R. (2024). Mixing Dynamics and Recovery Factor during Hydrogen Storage in Depleted Gas Reservoirs. Gas Science and Engineering, 128, 205382.en_US
dc.identifier.issn2949-9097
dc.identifier.urihttps://hdl.handle.net/11250/3139273
dc.description.abstractLarge-scale hydrogen storage is strategically important for society and depleted gas reservoirs have been proposed as a potential solution. However, the mixing with remaining hydrocarbon gas during injection/production cycles and the impact of different reservoir parameters on the hydrogen recovery factor (RFH2) have not been fully understood. We investigate mixing dynamics and analyze the effects of initial hydrocarbon recovery factor, reservoir permeability, well perforation length, intelligent completion, and fractures on RFH2. Fine-grid gas reservoir models with compositional simulation were used to simulate cyclic hydrogen storage. Mixing of injected hydrogen with remaining hydrocarbon gas occurred in three distinct phases in each cycle: 1) displacement of remaining hydrocarbon gas through pressure-driven flow during hydrogen injection, 2) density-driven flow of gases during the idle time after hydrogen injection, and 3) pressure-driven flow of gases towards the production intervals during the hydrogen production phase. Higher RFH2s were obtained when the storage process was initiated at higher hydrocarbon gas recovery factors. Storing hydrogen in reservoirs with lower permeability also led to higher RFH2s, provided the well pressure limits were not an issue. In conditions of a 5× to 15× increase in permeability, the injected hydrogen moved upward and spread laterally, positioning it farther from the wellbore. This made hydrogen production more difficult and placed the mixing zone and hydrocarbon gas closer to perforations. Shorter perforation lengths at the top of the formation resulted in the best RFH2s. Additionally, intelligent completions (that closed perforations producing gas with low hydrogen content) improved RFH2 by providing the possibility of purer hydrogen production. The presence of natural fractures significantly reduced hydrogen recovery, especially in the first few cycles. However, the influence decreased over time as highly conductive flow paths provided by fractures can contribute to the production of the accumulated unrecovered hydrogen from previous cycles.en_US
dc.language.isoengen_US
dc.publisherElsevier Inc.en_US
dc.rightsNavngivelse 4.0 Internasjonal*
dc.rights.urihttp://creativecommons.org/licenses/by/4.0/deed.no*
dc.subjecthydrogenen_US
dc.titleMixing dynamics and recovery factor during hydrogen storage in depleted gas reservoirsen_US
dc.typePeer revieweden_US
dc.typeJournal articleen_US
dc.description.versionpublishedVersionen_US
dc.rights.holder© 2024 The Authors.en_US
dc.subject.nsiVDP::Teknologi: 500::Berg‑ og petroleumsfag: 510en_US
dc.source.volume128en_US
dc.source.journalGas Science and Engineeringen_US
dc.identifier.doi10.1016/j.jgsce.2024.205382
dc.identifier.cristin2276311
dc.source.articlenumber205382en_US
cristin.ispublishedtrue
cristin.fulltextpostprint
cristin.qualitycode1


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record

Navngivelse 4.0 Internasjonal
Except where otherwise noted, this item's license is described as Navngivelse 4.0 Internasjonal