Blar i Master's theses (TN-IPT 2007-2017) på tittel
Viser treff 377-396 av 533
-
Plug and Abandonment Technology Evaluation and Field Case Study
(Masteroppgave/UIS-TN-IPT/2016;, Master thesis, 2016-06)In the North Sea, the average field age is increasing and a large number of wells needs to be plugged and abandoned in the future. P&A is regarded as an operation with no financial returns and is associated with significantly ... -
Plug and abandonment, milling operations and simulations
(Masteroppgave/UIS-TN-IPT/2014;, Master thesis, 2014-06-13)During plug and abandonment, there can be a need for removing casing to ensure that a proper cement barrier can be set. The conventional method for doing this is by performing milling oper ... -
Potential of evaporation for geothermal energy exploitation
(Masteroppgave/UIS-TN-IPT/2017;, Master thesis, 2017-06-13)This master thesis investigates the potential of using heat pipes as geothermal heating systems for domestic purposes. The total electric energy consumption in Norway used for heating purposes is estimated to be as much ... -
Pre/post-production uncertainty analysis applied on the Hyme field
(Masteroppgave/UIS-TN-IPT/2013;, Master thesis, 2013-06)The objective of this master thesis is to quantify how the estimated uncertainty, associated with the Hyme field, will change as more data becomes available. This will be done by identifying the key uncertainties and ... -
Prediction of dispersions and emulsions by using LedaFlow Q3D
(Masteroppgave/UIS-TN-IPT/2017;, Master thesis, 2017-06-15)Well streams in pipelines are often transported over relatively long distances. The well streams often consist of simultaneous flow of gas, oil and water. Oil and water affect each other by making emulsions, which influence ... -
Preparation of Activated Carbon from Biomass for High Performance Supercapacitors
(Masteroppgave/UIS-TN-IPT/2017;, Master thesis, 2017-06-15)Activated carbon was successfully synthesized from waste paper by physical, chemical and a combination of both activation procedures. The chemically activated carbon samples was achieved by using H3PO4 and KOH as agents. ... -
Processing and analysis of Vertical Seismic Profile data acquired while drilling (VSP-WD)
(Masteroppgave/UIS-TN-IPT/2012;, Master thesis, 2012)A Vertical Seismic Profiling While Drilling (VSP-WD) survey method was used to acquire data for processing analysis. This survey carried out in West Cameron in Offshore Louisiana by Schlumberger in 2005. A seismic source ... -
Processing techniques to enhance imaging of ultra-high frequency seismic data acquired with P-Cable technology
(Masteroppgave/UIS-TN-IPT/2017;, Master thesis, 2017-06-15)P-Cable seismic acquisition system is a rather new technology; developed through the past 20 years. Consequently, the use of P-Cable technology has been limited, although researchers still believe that further improvements ... -
Production performance analysis of well with different inflow technologies
(Masteroppgave/UIS-TN-IPT/2011;, Master thesis, 2011) -
Proper Cementing to Reduce Time and Cost
(Masteroppgave/UIS-TN-IPT/2016;, Master thesis, 2016-06-15)This work brings up some important aspects of cementing procedure with the aim of reducing WOC time, avoiding remedial cementing and referring to some new technologies regarding plug and abandonment. In the beginning, a ... -
Provenance of the Upper Cretaceous Lange-Lysing deep-marine sandstone in the Norwegian Sea: with implication for reservoir quality.
(Masteroppgave/UIS-TN-IPT/2017;, Master thesis, 2017-06)The provenance and reservoir properties of Upper Cretaceous Lange-Lysing sandstone in the Norwegian Sea have been determined by using integrated whole-rock geochemical, petrographic and detrital zircon U-Pb age dating by ... -
PSV sizing verification for Alvheim process equipment during gas blowby scenarios
(Masteroppgave/UIS-TN-IPT/2011;, Master thesis, 2011)The EPCI (Engineering, Procurement, Construction and installation) contractor which delivered the PSVs to Alvheim states that the PSVs are sized to handle a gas blowby scenario. Marathon Norge AS does not hold any documentation ... -
Raman spectroscopy applied to enhanced oil recovery research
(Master thesis, 2015-06-09)It is well established that aqueous chemistry affects the mechanical strength of chalk. Seawater tends to weaken chalk at reservoir temperatures and consequently the recovery rate. As more than 50 % of the oil in existing ... -
Real time production monitoring with prediction and validation
(Masteroppgave/UIS-TN-IPT/2009, Master thesis, 2009)This Master of Science studies Optimum Online’s real time estimated production at the Ekofisk Field. Information from offshore process sensors are used to validate the individual well estimates and to detect any deviation ... -
Recognition and quantification of petroleum source rocks from well log data and its applications
(Masteroppgave/UIS-TN-IPT/2011;, Master thesis, 2012-06)Petroleum source rocks constitute one of the main elements in petroleum systems. Several methods have been developed to characterize source rocks, mainly using geochemical and petrographical laboratory techniques to determine ... -
Reelwell drilling method - installation and cementation of 10 ¾’’ casing and 7" liner - method and case example
(Masteroppgave/UIS-TN-IPT/2013;, Master thesis, 2013-06)Current technology gives an opportunity to drill Extended Reach Drilling (ERD) wells with a tremendous length of horizontal departure. The Reelwell Drilling Method (RDM) is a drilling technology particularly suited for ... -
Reliability Based Casing Design
(Masteroppgave/UIS-TN-IPT/2017;, Master thesis, 2017-06)It is a well-known fact that wells are increasingly becoming extremely expensive and difficult to drill as well as develop due to increasing water depth, temperatures, and pressures. All these result in an increasing load ... -
Reservoir characterization and conformance control from downhole temperature measurements
(Master thesis, 2015-07-15)Temperature plays an important role in reservoir development since it affects fluid and formation properties and it is especially important for EOR deployment. Downhole temperature measurements have been available for ... -
Reservoir characterization of Sognefjord and Fensfjord formations across Gjøa field, North Sea, Norway
(Masteroppgave/UIS-TN-IPT/2013;, Master thesis, 2013-06-17)The Gjøa field was discovered in 1989 and first production started in 2010 located about 40 kilometers north of the Fram field. The reservoir contains gas above a relatively thin oil zone in Jurassic sandstones in the ... -
Reservoir characterization of the Lower Cretaceous clastic wedges in the southwestern Barents Sea using seismic analysis and rock physics diagnostic
(Masteroppgave/UIS-TN-IPT/2016;, Master thesis, 2016-06-17)The southwestern Barents Sea is an underexplored area of the Norwegian continental shelf, with a few discoveries in Triassic and Jurassic reservoirs. Recently drilled exploration wells on the Loppa High and the surrounding ...