Blar i Department of Mechanical and Structural Engineering and Materials Science (TN-IMBM) på tittel

Viser treff 506-525 av 1687

    • Dynamic analysis of a suspension bridge 

      Tveiten, Jan (Masteroppgave/UIS-TN-IKM/2012;, Master thesis, 2012)
      This master thesis is the final part of my Master degree in structural and material science at the University of Stavanger. The thesis consists of collecting and studying data for the Lysefjord Bridge in light of the ...

    • Dynamic analysis of a two-rotor wind turbine on spar-type floating platform 

      El Beshbichi, Omar; Xing, Yihan; Ong, Muk Chen (Peer reviewed; Journal article, 2021-07)
      The dynamic response of a two-rotor wind turbine mounted on a spar-type floating platform is studied. The response is compared against the baseline OC3 single-rotor design. Structural design shows how the two-rotor design ...

    • Dynamic Analysis of a Vessel-shaped Fish Farm for Open Sea 

      Høiland, Andreas Vangdal (Masteroppgave/UIS-TN-IKM/2017;, Master thesis, 2017-06-15)
      In recent years, aquaculture has been the fastest-growing animal food producing industry in the world. However, the absence of suitable production areas might potentially become the most limiting factor for future production ...

    • Dynamic analysis of damping system in FS car using ADAMS Multidynamic Simulations 

      Svendsen, Nick (Masteroppgave/UIS-TN-IKM/2014;, Master thesis, 2014-06-16)
      The aim of this thesis is to use manual calculations, ADAMS/Car and other CAE software to analyze the dynamic of the suspension system for Formula Student car. Manual calculations have been done to find the suitable ...

    • Dynamic analysis of emergency disconnect during workover operations 

      Kleppa, Sveinung (Masteroppgave/UIS-TN-IKM/2015;, Master thesis, 2015-06-15)
      Emergency disconnect from the stack-up with large rig offset during well intervention is considered as a critical operation. Failure of disconnection from the well can lead to a major accident. Unofficial figures suggest ...

    • Dynamic Analysis of Feed Pipes for Fish Farming in Open Sea 

      Gjuka, Asdren (Masteroppgave/UIS-TN-IKM/2017;, Master thesis, 2017-06-15)
      The demand for seafood is continuously growing throughout the world, while the number of sheltered locations for fish farming is decreasing. Consequently, the industry is pushed to fin nd new and innovative solutions to ...

    • Dynamic analysis of flexible gravity-based fish cages under accidental failures in the mooring system 

      Dewan, Pulkit (Masteroppgave/UIS-TN-IMBM/2019;, Master thesis, 2019-06-15)
      A growing population needs an increasing amount of high-protein and nutritious food. Having acknowledged that, there is a substantial increase in seafood production in the world today. Due to spatial and environmental ...

    • Dynamic Analysis of Floating Dock Operations with Corrosion-induced Holes at Ballast Tanks 

      ZAHI, TERRY (Master thesis, 2023)
      The corrosion at the ballast tanks is a concern risk for floating docks that have been in service for several decades. Corrosion events can result in severe accidents and huge economic costs. To migrate the corrosion risk, ...

    • Dynamic analysis of gravity based fish cage 

      Chang, Ying (Masteroppgave/UIS-TN-IKM/2017;, Master thesis, 2017-07-06)
      With the development of economy and growth of population, we are constantly facing the challenge of decreasing fish population and increasing needs in the fish market. Aquaculture is a practical way to fulfill this demand. ...

    • Dynamic analysis of lift-off operation of a subsea spool from a barge 

      Karatas, Ismail Gokay (Masteroppgave/UIS-TN-IMBM/2020;, Master thesis, 2020-07-15)
      The lift-off operation faces great operational challenges due to the harsh environment in the North Sea. Especially, the operation becomes more susceptible to environmental conditions when the installation method involves ...

    • Dynamic Analysis of Splash-zone Crossing Operation for a Subsea Template 

      Amer, Adham M.; Li, Lin; Zhu, Xinying (Peer reviewed; Journal article, 2022)
      Subsea templates are steel structures used to support subsea well components. Normally, offshore crane vessels are employed to install them to the target location on the seabed. Crossing the splash-zone during the lowering ...

    • Dynamic analysis of spur gear with backlash using ADAMS 

      Ambaye, Getachew A.; Lemu, Hirpa Gelgele (Peer reviewed; Journal article, 2020)
      Gear tooth profile can deviate from its initial design shape and size as a result of increasing service time under time-varying load, introducing external agents like debris, overheating due to friction, wear, and in ...

    • Dynamic and Fatigue Analyses of Suspended Power Cables for Multiple Floating Offshore Wind Turbines 

      Beier, Dennis (Master thesis, 2023)
      Floating offshore wind turbines (FOWTs) are installed to effectively capture energy from offshore wind in deeper water areas where building bottom-fixed offshore wind turbines is not practical. The present study focuses ...

    • Dynamic behaviour of jackets exposed to wave-in-deck forces 

      Raaij, Katrine van (PhD thesis UiS;17, Doctoral thesis, 2005)
      During the last decade, wave-in-deck loading on fixed offshore structures has increasingly been acknowledged as an issue of concern to the offshore oil and gas industry. Being mainly an issue for existing structures, the ...

    • Dynamic design and analysis of subsea CO2 discharging flowline for cargo submarines used for CCS in low-carbon and renewable energy value chains 

      Dai, Tianjiao; Yang, Shou; Xing, Yihan; Ma, Yucong (Peer reviewed; Journal article, 2022)
      Developing offshore low carbon and renewable energy value chains to realize a net-zero energy future requires combining offshore renewable energy and carbon capture storage (CCS) solutions. The subsea shuttle tanker (SST) ...

    • Dynamic loads on telescopic safety joint for workover riser 

      Fredrik Haugland, Danielsen (Masteroppgave/UIS-TN-IKM/2014;, Master thesis, 2014-06-05)
      The push in the industry towards increasing the weather window for marine operations offshore leads to a focus on new technology. When performing workover operations in a subsea well, the workover riser is a physical ...

    • Dynamic response analysis of a catamaran installation vessel during the positioning of a wind turbine assembly onto a spar foundation 

      Jiang, Zhiyu; Li, Lin; Gao, Zhen; Halse, Karl Henning; Sandvik, Peter Christian (Journal article; Peer reviewed, 2018-05-11)
      Installation of floating wind turbines is a challenging task. The time and costs are closely related to the installation method chosen. This paper investigates the performance of an efficient installation concept – a ...

    • Dynamic response of a floating bridge under wind conditions from field measurements 

      Syper, Joanna; Zhao, Ran (Masteroppgave/UIS-TN-IMBM/2020;, Master thesis, 2020-06-28)
      The long and slender floating structures across the wide and deep waters are exposed for considerable environmental loads. In this study, the dynamic response of a curved floating pontoon bridge supported by side mooring ...

    • Dynamic response of a floating offshore wind turbine 

      Stølsmark, Rasmus (Masteroppgave/UIS-TN-IKM/2010;, Master thesis, 2010)
      The ever increasing demand for renewable energy, combined with limited areas suitable for large wind farms, has put focus on the development of floating wind turbines. In this thesis the dynamic response of a floating ...

    • Dynamisk analyse av bruer med jordskjelvlast 

      Kabeya, Jean Nounou (Masteroppgave/UIS-TN-IKM/2011;, Master thesis, 2011)
      Dette arbeidet ble utført våren 2011, som avslutning på studien Mastergrad i Konstruksjon og Materialer, ved Universitet i Stavanger, Norge. Oppgaven var meget utfordrende, først og fremst på grunn av omfanget (se 0.2 ...